Smart Siren Ii Security System Installation
Smart Siren Ii Security System Installation. Locate the security siren connector (2), at the end of the harness lead that wraps around the top of the fuel tank. Remove the flanged hex nut (2) and flat washer (3) that retain.
#2 is the dummy hole where the connector was sitting, and the wire doesn't have a lot of play in it so the siren must go somewhere right there, i just can't see where. Something that you might want to consider since the hd security system that comes standard with the bike does not have a siren. Security and convenience in one.
Something That You Might Want To Consider Since The Hd Security System That Comes Standard With The Bike Does Not Have A Siren.
Locate the security siren connector (2), at the end of the harness lead that wraps around the top of the fuel tank. Smart siren module ii plugs into same spot as the ssm i and only hd 'bout $100 new anyway lol :yeahright. The protective cap and cable strap on the security siren connector can be discarded.
The Wire Sort Of Blocking The View Is Just The Antenna Wire For The Tssm And Not Relevant To This Problem.
Free shipping for many products! Smart pager ii only works with smart siren module ii as they use the proximity operating mode, where the new buttonless fob when moved away from the bike automatically arms the alarm system normally. What happens if you install maxi fuse, turn off ignition, alarm sets, move fob 25 feet away, walk up to bike and stand it up off jiffy stand to force it into an alarm state.
Install The Siren (1) With The Sounder Disc Aligning With The Holes In The Lower Bracket (2).
Insert security siren connector [142b] into the security siren receptacle (5) until the connector latches securely. Security and convenience in one. I am not positive but i believe the siren battery only get charged when ignition is on.
• Homologated For International Use.
Security and convenience in one. #2 is the dummy hole where the connector was sitting, and the wire doesn't have a lot of play in it so the siren must go somewhere right there, i just can't see where. Route the siren antenna wire (5) out through the cutout in the bracket, alongside the connector.
Security And Convenience In One.
Plug in this very loud siren for additional peace of mind that your motorcycle is protected. (warning, warning, alarm state.) does it continue to sound for 30 seconds. Place the siren bracket (4) onto the studs, and install the nuts (3) to secure the bracket.
Post a Comment for "Smart Siren Ii Security System Installation"